3D-s nyomtató AD597 K-típusú hőelem-hőmérséklet-szabályozó kártya Ultimaker modul

3D Printer AD597 K-type Thermocouple Temperature Control Board Module Ultimaker Advantages:1 , each one will do functional testing.2 , especially with a 3Pin 70cm connection for easy connection to the ramps1.4 use .3 , the official wiki design a diode D1 ( to prevent reverse power ) , resulting in a pressure differential between the two sides of the ground , so that the thermocouple output signal Sg, to the motherboard rear end becomes Sg Vs, so will lead to temperature allowed, our version using 0 ohm resistor in place of the diode temperature measurement more accurate. Special note:1 , and the official version is not fully consistent , revised official version of the differential problem , with 0 ohm resistor instead of a diode D1 .2 , due to low production , small welding difficulty , using manual welding. Suitable for : ramps1.4 and Ultimaker , etc. can be used. Package Included:
1 x 3D Printer AD597 K-type Thermocouple Temperature Control Bo
311578586451 - ali110 (281)